Panasonic UB-7320 - Manual (Page 38)

38
Optional Wall-mounting Kit (KX-B063)
Before attempting installation of this wall-mounting kit, we strongly recommend consulting with the building manager,
engineer, or architect. The installer needs to know the type of construction used for the wall intended for this
installation and the location of wall studs. Selection of hardware is critical for safe wall-mounting, and depends on the
nature of wall construction. Installation should not occur until this consultation takes place.
• Do not attach the electronic board to mortared walls. Accidental electric leakage from the wall-mounting
fixture bolts to metal laths or wire laths can cause heat, smoke or a fire.
1. Tools required:
A minimum of eight (8) pieces of appropriate wall-support hardware (molley, toggle, etc.)
NOTE: THIS HARDWARE MUST BE LOCALLY PROCURED, IT IS NOT INCLUDED IN THE KIT.
Drill (and drill bit of correct size) for hardware installation
Screw driver (Both phillips (+) and slotted (–) will be required.)
Tape measure
Tape or thumb-tacks (2 pcs)
Bubble type level
2. Pre-requisites
1. Before installation, make sure that the wall intended for installation is capable of supporting flush-
mounted.
UB-7320 is 205 kgf (452 lbs.).
2. The position of the intended installation is of adequate size for the selected Panaboard.
UB-7320 is 1,664 mm (H)
× 1,648 mm (W) [5' 6” (H) × 5' 5" (W)].
3. An outlet is within 3 m (9' 10 1 /
8
" ), and not located behind the Panaboard.
■ Accessories
The package box for the optional wall-mounting kit includes the parts noted below; please confirm that all parts are
present before beginning installation. Eight screws for mounting the fixtures on the wall are not provided. Please
purchase the appropriate wall-mounting hardware (sold in stores). Refer to page 40.
*These are used for other models.
No. Part name Illustration Q’ty No. Part name Illustration Q’ty
Wall-mounting
fixture L
2
Screw
(Not use*)
M4 x 16 mm ( 20 /
32
”)
4
Wall-mounting
fixture R
2
Wall-mounting
template
(Not use*)
1
Wing bolt
M5 x 12 mm ( 15 /
32
")
(For mounting of the
electronic board)
2
Use the wall-
mounting template
provided with
UB-7320.
Caution