Planar CM17.4SXAD - Manual (Page 21)

Installing the Display | 9
VS17.4SXAD / CM17.4SXAD ( 020-0168-00B )
Connecting a Video Device
Use the following instructions if you are hooking up a camera, VCR, or
other S-Video or Composite Video device, and not using the VGA or DVI
input simultaneously. These instructions apply to S-Video and Composite
Video input-equipped displays only.
1 Press the Power/Menu button until the Power ON indicator blinks.
After a moment, a No Signal Coming message appears.
2 Wait for the No Signal Coming message to disappear, approximately
3 to 5 seconds.
3 Press the Power/Menu button to display the VGA → VIDEO menu.
4 Press the PLUS or MINUS ( / ) control to enter video mode.
5 Press the UP ( ) arrow to change video modes if you are using
an alternate video source.
6 Press the PLUS or MINUS ( / ) control to select the desired
video mode.
Connecting the Optional Touch Screen
If your VitalScreen CSR or VitalScreen CR display has the optional touch
screen, connect the display 9-pin D-sub serial port to the computer 9-pin
RS-232 serial port using the cable supplied with the touchscreen package.
Next, connect the RS-232 cable to the 9-pin serial port on the back panel
of the display.
Do not operate the touch screen with sharp objects, such as a scalpel.
Sharp objects can scratch or damage the touch screen. A damaged touch
screen may pose a safety hazard.
Mounting the Display
When mounting your display, such as to a wall bracket or an
articulated swing arm, make sure the maximum length of the
screws inserted into the display mounts is 9 millimeters. Forcing
the screws deeper into the mounts and exceeding this maximum
length may damage the display.