beautypg.com

Pride Mobility Jazzy 610 2SP User Manual

Page 37

background image

Jazzy 610 Series

www.pridemobility.com

37

V I I . C A R E A N D M A I N T E N A N C E

Figure 24. Jazzy 610 Drive Wheel

TIRE

DRIVE WHEEL NUT

DRIVE WHEEL WASHER

Figure 25. Jazzy 610 Drive Wheel Disassembled

TUBE

FRONT RIM HALF

REAR RIM HALF

NUTS

WASHERS

AXLE KEY

WHEEL HUB

AXLE SLOT

Follow these easy steps for a quick and safe repair for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate it before removing the wheel.
4. Remove the drive wheel nut and washer from the axle. See figure 24.
5. Pull the wheel off the axle.
6. Remove the nuts and washers from the wheel hub and separate the front and rear rim. See figure 25.
7. Remove the old tube from the pneumatic tire and replace it with a new tube or replace the entire assembly if it is a

solid tire.

8. Reassemble the rims and reinstall the nuts and washers to the wheel hub.
9. Slide the wheel back onto the axle. Make sure that the key is in the axle slot.
10. Reinstall the drive wheel nut and washer onto the wheel axle and tighten.
11. Inflate the pneumatic tire to 35 psi (2.4 bar) if equipped with pneumatic tires.
12. Remove the power chair from the blocks.

Battery Replacement

A battery wiring diagram is printed on a decal located on the front battery tray. See VI. “Batteries and Charging” for
correct battery specifications.

WARNING! Do not replace battery when seat is occupied.

WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.

Wear goggles and gloves when handling batteries and wash hands after handling.

WARNING! Power chair batteries are heavy. See specifications table. If you are unable to lift that

much weight, be sure to get help. Use proper lifting techniques and avoid lifting beyond your

capacity.

WARNING! Do not mix or match new and old batteries. If you encounter a situation where one

battery needs to be replaced, then replace both batteries. Refer to the specifications table in this

manual and the manual supplied with the battery charger for recommended type and capacities.

This manual is related to the following products: