Pride Mobility Jazzy 610 2SP - Manual (Page 23)

Jazzy 610 Series www.pridemobility.com 23
V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase
your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller position.
NOTE: If your power chair is equipped with a Synergy Seat, Specialty Seat, or TRU-Balance Power Position-
ing System, refer to the seat adjustment information contained in separate manuals. If your power chair is
equipped with a contoured seating system, refer to the following information.
WARNING! If your power chair was configured by your authorized Pride Provider, please consult
your healthcare professional before changing the seat position or making any other adjustment.
Some adjustments may degrade your power chair’s performance and safety by changing its center
of gravity.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
TRAPEZE BARS
RETAINING CLIPS
SEAT POSTS
Figure 13. Seat Height Adjustment - Trapeze Bars
SCREWS
Figure 12. Seat Height Adjustment - Seat Latch Safety
You may need the following to make comfort adjust-
ments:
! metric/standard socket set and ratchet
! adjustable wrench
! thread lock
Seat Height and Seat Angle Adjustment
You can change the seat height to one of four positions by
raising the front and rear trapeze bars. If you raise or lower
only one trapeze bar (front or rear), you can also change
the seat base angle (dump).
To change the seat height:
1. Turn off the power to the controller.
2. Unlock the rear shroud fasteners and remove the rear
shroud. See figure 6.
3. Disconnect the controller connector(s) from the power
base. See figure 7.
4. Flip up the seat latch safety. See figure 12.
5. Squeeze the seat latch and release the seat from the
front trapeze bar. See figure 12.
6. Slide the seat forward and remove it from the power
base.
7. Loosen the screws that attach the trapeze bars to the
seat posts. See figure 13.
8. Remove the retaining clips that secure the seat posts to
the power base. See figure 13.
9. Move the trapeze bars up or down to the desired height.