Controlling the rest of your system, Operating multiple receivers, Setting the remote to control other components – Pioneer VSX-919AH-S User Manual
Page 72: Selecting preset codes directly, Controlling the rest of your system 09, Chapter 9
Controlling the rest of your system
09
72
En
Chapter 9:
Controlling the rest of your
system
Operating multiple receivers
The remote control included with this receiver
can be used to operate up to three other
receivers (of the same model as this receiver)
in addition to this receiver. The receiver to be
operated is switched by inputting the preset
code to set the remote control setting.
• Set the remote modes on the receivers
before using this function (see Remote
Control Mode Setup on page 100).
1
Check the operation selector switch to
MAIN.
2
Press
.
3
Press and hold REMOTE SETUP, then
release it after the LED flashes twice.
4
Use the number buttons to enter the 5-
digit preset code (see below).
• Receiver 1: 6 1 9 3 5 (Default)
• Receiver 2: 6 2 6 3 0
• Receiver 3: 6 2 6 3 1
• Receiver 4: 6 2 6 3 2
When the preset code is fully input, the LED
flashes once to indicate that the setting is
completed.
To operate another receiver, start over from
step 1 to input its preset code.
Setting the remote to control
other components
Most components can be assigned to one of
the input function buttons (such as DVD or
CD) using the component’s manufacturer
preset code stored in the remote.
However, there are cases where only certain
functions may be controllable after assigning
the proper preset code, or the codes for the
manufacturer in the remote control will not
work for the model that you are using.
Note
• You can cancel or exit any of the steps by
pressing
. To go back a step,
press RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.
Selecting preset codes directly
1
Press the input function button for the
component you want to control.
1
When assigning preset codes to TV CONTROL,
press TV CTRL here.
2
Press and hold REMOTE SETUP, then
release it after the LED flashes twice.
3
Use the number buttons to enter the 5-
digit preset code.
See Preset code list on page 115.
RECEIVER
Note
1 You can’t assign
, TUNER or iPod/USB.
RECEIVER
RECEIVER
VSX-1019_DF.book 72 ページ 2009年3月13日 金曜日 午前9時58分