Pioneer VSX-919AH-S - Manual (Page 108)

Additional information 12
108
En
Remote control
During playback of a
Surround EX or DTS-ES
source on the SBch AUTO
setting, EX or ES does not
appear, or the signal is not
properly processed. • The source may be Dolby Surround EX/DTS-ES software, but it has no flag to
indicate it is 6.1 compatible. Set to SBch ON (see Using surround back channel
processing on page 55), then switch to the Standard EX listening mode (see
Listening in surround sound on page 52).
During playback of DVD-
Audio, the display shows
PCM. • This will occur when playing DVD-Audio material over the HDMI connection.
This is not a malfunction.
The power turns off
automatically and some
indicator flashes, or some
indicator flashes and the
power does not turn on. • See the Power section (page 101).
Symptom Remedy
Cannot be remote controlled. • Set a 5-digit preset code corresponding to the receiver to be operated in the
remote control (see Operating multiple receivers on page 72).
• Check whether the receiver’s remote control mode is properly set (see
Remote Control Mode Setup on page 100).
• Try replacing the batteries in the remote control (see Loading the batteries on
page 7).
• Be sure to operate within 7 m and a 30º angle of the remote sensor on the
front panel (see Operating range of remote control unit on page 13).
• Check that there are no obstacles between the receiver and the remote
control.
• Make sure that there is no fluorescent or other strong light shining on to the
remote sensor.
• Check the connections of the CONTROL IN jack (see Operating other Pioneer
components with this unit’s sensor on page 32).
Other components can’t be
operated with the system
remote. • If the battery ran down, the preset codes may have been cleared. Re-enter the
preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset
codes.
Symptom Remedy
VSX-1019_DF.book 108 ページ ２００９年３月１３日 金曜日 午前９時５８分