Pioneer VSX-919AH-S - Manual (Page 34)

Connecting your equipment 03
34
En
Connecting an iPod
This receiver has a dedicated iPod terminal
that will allow you to control playback of audio
content from your iPod using the controls of
this receiver.
• Switch the receiver into standby then use
the supplied iPod cable to connect your iPod
or iPhone to the iPod/iPhone/USB terminal
on the front panel of this receiver.
• Push down on the PUSH OPEN tab to
access the iPod/iPhone/USB terminal.
• It is also possible to connect using the
cable included with the iPod, but in this
case it is not possible to view pictures via
the receiver.
• For the cable connection, refer to also the
operating instructions for iPod.
Connecting a USB device
It is possible to playback files using the USB
interface on the front of this receiver.
• Switch the receiver into standby then
connect your USB device to the iPod/iPhone/
USB terminal on the front panel of this
receiver.
• Push down on the PUSH OPEN tab to
access the iPod/iPhone/USB terminal.
MENU

 
MASTER
VOLUME
MCACC SETUP MIC
SPEAKERS
VIDEO L R AUDIO
CONTROL MULTI-ZONE ON / OFF
VIDEO INPUT
VIDEO INPUT R L AUDIO VIDEO USB MCACC SETUP MIC
USB
iPod iPhone
iPod iPhone
iPod
iPod cable
(supplied)
This receiver
MASTER
VOLUME
MCACC SETUP MIC
SPEAKERS
VIDEO L R AUDIO
CONTROL MULTI-ZONE ON / OFF
VIDEO INPUT
VIDEO INPUT R L AUDIO VIDEO USB MCACC SETUP MIC
USB
iPod iPhone
iPod iPhone
USB mass
storage device
This receiver
VSX-1019_DF.book 34 ページ ２００９年３月１３日 金曜日 午前９時５８分