Remote control mode setup, Flicker reduction setup, Remote control mode setup flicker reduction setup – Pioneer VSX-919AH-S User Manual
Page 100: The system and the other setup 11

The system and the other setup
11
100
En
Remote Control Mode Setup
• Default setting: 1
This sets this receiver’s remote control mode to
prevent erroneous operation when multiple
units of the receiver are being used.
1
1
Select ‘Remote Control Mode Setup’
from the Other Setup menu.
2
Select the Remote Control Mode setting
you want.
3
Select “OK” to change the remote control
mode.
4
Follow the instructions on the screen to
change the remote control’s setting.
See Operating multiple receivers on page 72.
5
When you’re finished, press RETURN.
You will return to the Other Setup menu.
Flicker Reduction Setup
• Default setting: 4
The GUI screen’s resolution can be increased.
If you feel the GUI screen is hard to see, try
changing this setting. Note that the resolution
in this setting only affects the GUI screen; it
has no influence on the video output.
1
Select ‘Flicker Reduction Setup’ from the
Other Setup menu.
2
Select the Flicker Reduction setting you
want.
3
When you’re finished, press RETURN.
You will return to the Other Setup menu.
Note
1 If you change this receiver’s setting, also change the setting on the remote control.
4d.Other Setup
A/V RECEIVER
Exit
Return
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6. Remote Control Mode Setup
7. Flicker Reduction Setup
2. Multi Ch In Setup
1. KURO LINK Setup
4d6.Remote Control Mode Setup
A/V RECEIVER
Exit
Cancel
Remote Control Mode : 1
OK
4d.Other Setup
A/V RECEIVER
Exit
Return
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6. Remote Control Mode Setup
7. Flicker Reduction Setup
2. Multi Ch In Setup
1. KURO LINK Setup
4d7.Flicker Reduction Setup
A/V RECEIVER
Exit
Finish
Flicker Reduction :
4
VSX-1019_DF.book 100 ページ 2009年3月13日 金曜日 午前9時58分