Panasonic NV-VP60 Series - Manual (Page 38)

RQTV0115
38
38
Recording from DVD to VHS
You can record the contents of a disc onto a video cassette.
≥Select the unit viewing channel (or the AV input) on the TV.
≥Insert a video cassette with an intact erasure prevention tab.
≥Press [DVD SELECT] (
l 8).
≥Select the desired recording mode ( l 16).
Only discs that are not copy protected can be used.
≥Press [DVD SELECT] (
l 8).
≥Set “On-Screen Messages” to “Off” (Setup menu l 37).
≥Insert the disc to be recorded ( l 23). When you copy NTSC discs,
select “NTSC” in “NTSC Disc Output” (Setup menu l 37).
.........................................................................................................................................................................................................................
[1] Press [VHS SELECT] and then
press [INPUT SEL] repeatedly.
Select “dc” channel.
≥Recording is allowed only when the
VHS input channel is set to “dc” ( l below).
.........................................................................................................................................................................................................................
[2] Press [DVD SELECT] and then press [ 1PLAY].
Start playing the disc and find the playing start point.
.........................................................................................................................................................................................................................
[3] Press [ ;/DPAUSE].
.........................................................................................................................................................................................................................
[4] Press [VHS SELECT] and then press [ 1PLAY].
Start playing the video cassette and find the recording start
point.
.........................................................................................................................................................................................................................
[5] Press [ ;/DPAUSE] and then press [¥REC].
Put the unit in the recording standby mode.
.........................................................................................................................................................................................................................
[6] Press [;/DPAUSE].
VHS recording and disc play start at the same time.
¬ To stop recording
1) Press
[ ∫STOP]. Recording will stop.
2) Press [DVD SELECT] and then press [ ∫STOP].
Disc play will stop.
Notes:
≥You can select the audio channel to be recorded on the Normal
audio track when copying a bilingual DVD ( l 21).
≥Recording cannot be done if using a copy protected disc. By
pressing [ ¥REC] at “dc” channel during DVD playback, the
message “COPYING OF THIS MATERIAL IS NOT ALLOWED.”
appears on the TV screen.
You can copy programmes on a DVD-RAM disc to a video cassette
with One-touch operation.
≥This function allows DVD-RAM discs recorded by Panasonic DVD
recorders to be copied.
≥Insert the disc containing the programme to be copied ( l 23).
≥This function allows you to record the whole content on a disc
automatically. Confirm that the remaining tape time is sufficient for
recording.
While stopped, press and hold [DVD-RAM
COPYING] for 5 seconds or more.
When the disc is played all of the content or the tape reaches its end,
this unit automatically stops copying.
≥The message is displayed on TV screen for a few seconds when
DVD-RAM copying is completed.
¬ To stop recording
Press [
∫STOP].
¬ When “ ” and “ ” is flashing
Check the settings again.
Notes:
≥In this function, the index signal is automatically added on the tape
for each of the programmes. You can find the desired programme
with these index signals (
l 19).
≥This function does not work during timer recording standby mode.
≥When the copying starts, “On-Screen Messages” in the Setup
menu is automatically set to “Off”. The “dc” channel is automatically
selected (
l below).
≥If you press [DVD-RAM COPYING] again, the copying starts at the
stop position memorized (Resume function l 23). “ ” in the
unit’s display flashes.
Manual Copying
DVD-RAM Copying
“dc” channel
≥When the disc is played with the “dc” channel set, the TV
screen displays the disc video.
VP60GCS.book Page 38 Monday, March 6, 2006 3:23 PM