Philips STREAMIUN WACS7500 - Manual (Page 95)

Frequently asked questions 91
ENGLISH
Problem Solution
Nothing appears on the synchronous
display of the 2-way remote control
of
even after the set is switched
on.
You have switched on the set with the y button on
the set and not the y button on the 2-way remote
control. Press REFRESH on center’s 2-way remote
control to synchronize its display.
The remote control does not
function properly. • Reduce the distance between the remote control
and the set.
• Insert the batteries with correct polarity (+/- as
indicated inside the compartment).
• Replace the batteries.
• Point the remote control directly towards the IR
sensor.
The screen of is stuck in a menu
or shows no response for a long
period of time (2-5 minutes).
Please first try to press y to go to power-saving mode.
If the problem persists, restart the power (disconnect
and reconnect the mains plug) to reset
.
‘No Disc’ / ‘Cannot read CD’ is
displayed. • Insert a suitable disc.
• Check if the disc is inserted with the graphics side
(label) facing you.
• Wait for the moisture condensation on the lens to
clear.
• Replace or clean the disc, see 1.5 Maintenance.
• Use a finalized CD-RW or CD-R.
Sound cannot be heard or is of poor
quality. • Adjust the volume.
• Disconnect the headphones.
• Switch off MUTE.
The disc skips tracks. • Replace or clean disc.
• Switch off SHUFFLE.
Sound skips during MP3/WMA
playback. • The MP3/WMA file may be made at a compression
level exceeding 320kbps. Use a lower compression
level to rip audio CD tracks.
• Replace or clean disc.