2 connect ac power, 3 set up wi-fi connection, 4 rear connections – Philips STREAMIUN WACS7500 User Manual
Page 26: Connect ac power, Set up wi-fi connection between center and station, Rear connections
Installation
22
3.2
Connect AC power
Ensure that all rear connections are established before you power up the set.
Connect the AC power cord to the mains outlet.The set is now powered up (switched on).
When in Standby or Eco Standby mode,
and
still consume some power.
To disconnect the system from the power supply completely, remove the power plug from the
mains outlet.
For users in the U.K., please follow the instructions on page iii.
3.3
Set up Wi-Fi connection between Center (
) and Station (
)
Note
• Always press & hold
y
to switch the set to Eco standby (power-saving mode) before removing its
power plug.
• Always power up the
first, and then power up the
.
• Never block
from
by thick walls or more than one wall.
• Avoid installation near large metal objects.
The Wi-Fi connection starts automatically when you power up both
and
.
The first time you set up a Wi-Fi connection place
and
side by side on a level and sturdy
surface.
1
Using the supplied power cables, connect first
and then
to the power supply.
>
and
are ready for use.
Tip
For better Wi-Fi reception, rotate the Wi-Fi antenna or adjust the location of
and
.
3.4
Rear connections
Note
• Never connect or disconnect power cables when the mains supply is switched on.
• Install
and
within easy reach of suitable AC power outlets.
Important! Always press & hold
y
to switch the set to power-saving mode before removing its
power plug.