Philips STREAMIUN WACS7500 - Manual (Page 82)

The following steps show how to get DNS and Gateway settings of the current
network from the PC connected to the same network:
1 On your PC, click Start > Run
2 Type cmd and click OK
3 Type ipconfig/all
4 Write down the DNS and Gateway of the current connection.
On
1
Press MENU to enter the menu screen.
2 Use
3
or
4
and
2
to enter Settings followed by Network, then Wired.
3 Press
2
to continue.
Set DNS
1
Enter the DNS server you wrote down.
2 Press OK to confirm.
3 Press OK to skip Set DNS2.
Tip
If necessary, follow Steps 1 and 2 above to set a secondary DNS server in Set DNS2.
Set Gateway
1
Enter the Gateway you wrote down.
2 Press OK to confirm.
Set proxy
1
If you are using a proxy server to visit websites, enable Proxy and proceed with the proxy
setting as prompted, then press
OK to confirm Otherwise, press OK to skip.
2 Choose to apply the settings as prompted.
> Settings will change.
Connection to station could be lost appears.
Network settings 78