Paxar 9445 - Manual (Page 14)

11. Pull enough supply from the roll to reach the printhead.
12. Hold down the lower supply guide.
13. Feed the supply past the out-of-stock switch, between the
upper and lower supply guides, and up past the printhead.
14. Align the supply with the top edge of the upper guide and
slide it against the back wall (away from you). Continue
threading the supply up to the printhead as shown. Make
sure the ribbon does not snag or wrinkle.
Out-of-Stock
Switch
Printhead
Lower Supply
Guide
Upper Supply
Guide
Supply
Outer Supply
Holder
9445 Equipment Manual
2-6