beautypg.com

Problem solving for programmed recordings, Problem solution, Programming a recording (timer) – Philips VR270B/07 User Manual

Page 30

background image

26

22:00

5

Press TIMER k . The video recorder display will read, for instance,
'END

22:00'.

If required, change the end time of the recording with

P ;q ,

P =r or the number buttons 0-9 on the remote control.

Programme number of the '

E1' scart socket

You can also programme recordings from external sources (via scart socket

EXT.1 AV 1

).

6

When all information is displayed correctly, confirm with TIMER k .
'

OK' will briefly flash in the video recorder display. The programming

information is stored in a TIMER block.

7

Insert a cassette with an intact security tab (unprotected).

8

Switch off with STANDBY/ON m .
The programmed recording will only function when the video
recorder is switched off with STANDBY/ON m .
If any of the TIMER blocks are in use, ' k ' will light up on the video
recorder display.

Problem solving for programmed
recordings

PROBLEM

SOLUTION

The video recorder
does not react

b

While a programmed recording is being made, you cannot operate your video recorder manually.
If you want to cancel the programmed recording, press STANDBY/ON m .

A cassette was
automatically ejected
during recording

b

The end of the tape was reached during recording.

Error message: '

CASS'

'

k

' will flash in the

video recorder display

b

No cassette was inserted. Insert a cassette and switch off the video recorder using

STANDBY/ON m .

The '

PROT' error

message appears
briefly in the display
then the cassette is
ejected

b

A cassette was inserted with the security tab removed. Undo the erase protection (chapter
'Manual Recording', section 'Preventing accidental erasing of cassettes') or insert a different
cassette.

Error message: '

FULL'

b

If this error message appears after pressing TIMER k , then all TIMER blocks are already
programmed. No more recordings can be programmed. If you want to clear or check a
programmed recording (TIMER block), select it with P ;q or P =r .

'

ERR' appears in the

display

b

The data for the recording could not be transferred. Please check date, start time and end time
of the programmed recording.

Programming a recording (TIMER)

This manual is related to the following products: