Panasonic PT-AE700 - Manual (Page 8)

E NGLISH -15
Preparation
14-E NGLISH
* ) ( '
# % & $
)
(
&
*
.
/
'
-
2
1
+
0
,
Projector control panel
Remote control unit
# Power indicator (pages 24, 26 and 27)
This indicator illuminates red when the main power is switched on (standby
mode), and it illuminates green when a picture starts to be projected.
$ LAMP indicator (page 49)
This indicator illuminates when it is time to replace the lamp unit. It flashes
if a circuit abnormality is detected.
% TEMP indicator (page 48)
This indicator illuminates if an abnormally high temperature is detected
inside the projector. If the temperature rises above a certain level, the
power supply will be turned off automatically and the indicator will flash.
& Arrow (F F, G G, I I and H H) buttons (page 38)
These buttons are used to select and adjust items in the on-screen menus.
' ENTER button (page 38)
This button is used to accept and to activate items selected in the
on-screen menus.
( MENU button (page 36)
This button is used to display the “MAIN MENU”. When a menu screen is being
displayed, it can be used to return to a previous screen or to clear the screen.
) INPUT select buttons (page 25)
These buttons are used to switch the input signals from the connected equipment.
* POWER button (pages 24 and 26)
+ LIGHT button (page 29)
This button is used to illuminate the buttons on the remote control unit.
, KEYSTONE button (page 28)
This button is used to correct keystone distortion of the projected image
when the projector position is tilted upward or downward.
- FREEZE button (page 28)
This button is used to momentarily freeze projection so that a still picture is
displayed.
. PICTURE MODE button (page 29)
Pressing this button will change the picture mode.
/ USER MEMORY button (page 35)
This button is used to display the “MEMORY LOAD” menu.
0 COLOR MANAGEMENT button (page 32)
This button is used to display the “COLOUR MNGMT” menu.
1 ASPECT button (page 30)
This button is used for aspect adjustment (vertical and horizontal
proportions).
2 NORMAL button (page 39)
This button is used to reset the projector adjustment values to the factory
default settings.