Panasonic SA-HE75 EN - Manual (Page 12)

POWER
SFC MODE
8
SPEAKERS
PHONES
DSP
SOUND MODE
DOLBY
PRO LOGIC 2
-HE LP
–RESET
-BAND
–FM MODE
MEMORY PRESET 2 TUNING 1
12
RQT6847
Control guide
TUNED
STEREO
MONO SPEAKERS
kHz
MHz
PRO LOGIC 2
DIGITAL
SOUND MODE
STEREO SURROUND
SFC
L C R
SL
S
SR LFE
PCM
FIX M
[SOUND MODE, STEREO, SURROUND, SFC]
DSP sound mode indicators.
Show the current DSP sound mode.
[kHz, MHz]
Frequency unit indicators.
kHz: AM, MHz: FM
The display
[SPEAKERS]
Speaker indicator.
Lights when the speakers are on.
General display
Shows the input mode, radio frequency, and other general information.
[TUNED, MONO, STEREO, ˜ ]
Radio indicators.
TUNED:
A station is tuned.
MONO: You have switched to monaural mode with [-BAND,
–FM MODE] to improve reception.
STEREO: A stereo FM broadcast is tuned.
˜ : Flashes during presetting.
[POWER, 8 ]
P ress to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a small amount of power.
[SPEAKERS]
Turning the speakers off automatically engages the STEREO mode
(when listening through headphones, for example).
[-HELP, –RESET]
Press if an error message appears. A message offering a possible
solution scrolls across the display.
To reinitiate the unit’s settings, press and hold until “RESET” appears.
[PHONES]
Headphone jack
Plug type: 6.3 mm (1/4") stereo
Avoid listening for prolonged periods of time to prevent hearing damage.
Turn the speakers off when using the headphones.
[TUNING, 2 , 1 ]
For tuning the radio and selecting preset stations.
Press and hold until the frequency starts scrolling to start automatic
tuning. Tuning stops when a station is found.
[PRESET]
Press to allow preset station selection with [TUNING, 2 , 1 ].
[-BAND, –FM MODE]
For switching between AM and FM.
If reception is poor in FM, press and hold until “MONO” appears to
switch to monaural mode.
[DSP SOUND MODE]
For selecting “STEREO”, “SURROUND” or “SFC”.
[MEMORY]
For presetting radio stations.
[SFC MODE, < , > ]
For selecting the SFC modes.
[DOLBY PRO LOGIC 2 2 ]
Use when “ % PRO LOGIC 2 ” lights in the SURROUND mode.
Operations