Panasonic SC-BT100 - Manual (Page 36)

36
RQT9129
Optional connections and settings
Use outdoor antennas if FM/AM radio reception is poor.
≥Disconnect the antenna when the unit is not in use.
≥Do not use the outdoor antenna during an electrical storm.
§ Rework your outdoor antenna’s 75 ≠ coaxial cable as follows.
You can enjoy 7.1ch surround sound by connecting an amplifier using audio cable via the SURROUND and SURROUND BACK terminals.
Using FM/AM outdoor antenna (optional)
Connection to an amplifier via the SURROUND and SURROUND BACK terminals
OPTICAL IN
L
R
DIGITAL
COMPONENT VIDEO OUT
VIDEO OUT
Y
AUX P R
P B
AV OUT
FM ANT
ANT
EXT
LOOP
AM
75 ǡ
GND
ANT
LOOP
Leave the AM loop
antenna connected.
AM outdoor antenna
[Using a vinyl wire (not included)]
Run a piece of vinyl wire horizontally
across a window or other convenient
location.
FM outdoor antenna
[Using a TV antenna (not included)]
≥Disconnect the FM indoor antenna.
≥The antenna should be installed by a
competent technician.
75 ≠ coaxial cable §
(not included)
Antenna plug (not included)
5 m to 12 m (16 ft. to 39 ft.)
Main unit



1 Remove a piece of the outer
vinyl insulator.
2 Carefully pull the tabs apart
to remove the cover.
3 Install the coaxial cable.
Clamp the cable conductor, and
wind it on so that it does not
contact anything else.
4 Attach the cover.
10 mm ( 13 / 32
z)
10 mm ( 13 / 32
z) Peel back
7 mm ( 9 / 32
z) Clamp with pliers
OPTICAL IN
L
R
DIGITAL
COMPONENT VIDEO OUT
VIDEO OUT
Y
AUX P R
P B
SURROUND SURROUND BACK
AV OUT
SPEAKERS
R L 6 ǡ 6 ǡ
CENTER
6 ǡ
SUBWOOFER FRONT
6 5 2 1
FM ANT
ANT
EXT
LOOP
AM
75 ǡ
GND ANT LOOP
AC IN
OUT
L
R
SURROUND
BACK
L
R
SURROUND
Main unit
Amplifier
Audio cable
(not included)
Surround back speakers
≥“[W2S]” or “[W4S]” blinks if you do not use
the wireless system. In this case, remove
the digital transmitter.
Surround speakers
SC-BT100P-ENG.book 36 ページ ２００８年２月２０日 水曜日 午後６時２２分