Precision Power 355cs - Manual (Page 18)

1
After all the connections and any necessary adjustments have been made snap
the cover back in place .
connecting the system
Trim the speaker wire as needed . Strip about 1/4" (6 mm) of the insulation from
the ends . Twist the exposed strands thoroughly to prevent any loose strands from
causing a short circuit . You may also "tin" the wire with a soldering iron . The wires
attach to a removable connector which in its assembled position has the screws
facing the bottom of the crossover . Insert the prepared wire into the appropriate
location (see diagram or refer to the crossover circuit board) in the connector strip
and tighten the screws to secure the wires in place . Be sure to note the polarity
marking on the circuit board .