Precision Power 355cs - Manual (Page 12)

1
Install the speakers by gradually tightening each mounting screw . Tighten the
screws until the speaker is well seated, but take care not to over-tighten .
tWeeter installation
The speaker system is supplied with five different tweeter mounting options:
coaxial, surface, surface angle, flush, and angled flush mount . After you have
decided which option is best suited to your installation, refer to the following
sections for specific details on mounting the tweeter .
coaxial mount
These components have the unique ability to also be used as a coaxial speaker
in specific applications . This allows the tweeter to be placed directly in the center
of the woofer without obstructing the voice coil or the function of the woofer .
CAUTION: Use caution to not damage the speaker cone in the procedure
described in the next steps .
Unscrew and remove the center bullet from the threaded mounting post by turning
the bullet counterclockwise as shown in the following illustration . retain the bullet
for future use .
Turn bullet nose
counterclockwise
Threaded mounting
post
Install the tweeter into the extension housing by first threading the tweeter wires
through the extension housing and then installing the tweeter into the mounting
slots of the housing and turn the tweeter counterclockwise to lock the tweeter in
place .