beautypg.com

Patton electronic 2190 User Manual

Page 5

background image

4.2 AT COMMANDS

Refer to the following AT Command Set Chart below. This chart

identifies the command function and describes the elements of the
command.

AT Command Sets

AT Command Sets (continued)

A

A/

Bn

Dn

En

Hn

ATB0

ATB1

ATE0
ATE1

ATH0

ATH1

Answer Command
Forces the modem to go off-hook in answer mode

without waiting for a ring.

Repeat Last Commannd

Repeat the last command line it executed. Not
preceded with AT nor followed by pressing the
[Enter] key.

Select ITU-T/BELL Mode
Selects ITU-T operation at 300bps or 1200bps during
Call Establishment . (Default)
Selects BELL operation at 300bps or 1200bps during
Call Establishment.

This command directs the modem to go on-line, dial
according to the string entered and attempt to establish
a connection.

Echo Command
Disables command echo
Enables command echo (Default)

Hang Up the Telephone Line
The modem will release the line if the modem is
currently on-line, and will terminate any test (AT&T) that
is in progress. (Default)
If on-hook, the modem will go off-hook and enter
command mode.

Command

Description

In

ATI0
ATI1

ATI2

ATI3

ATI5
ATI6

Ln

ATL0
ATL1
ATL2
ATL3

Mn

ATM0
ATM1

ATM2
ATM3

Nn

ATN0
ATN1

On

ATO0
ATO1

Identification Command
Reports product code "56000".
Calulates the ROM checksum and reports the least
significant byte of the checksum in decimal.
Calculated the ROM checksum and compares it with
the prestored checksum.
Reports firmware revision (F), basic model (e.g., V34),
application code (A), and interface type code (I)
typically in the form VF,FFF-V34_A1.
Reports Country Code parameter.
Reports modem data pump model and internal code
revision.

Speaker Volume Control
Low speaker volume
Low speaker volume (Default)
Medium speaker volume
Higher speaker volume

Speaker Control
Speaker is always off.
Speaker is on during call establishment, but off when
receiving carrier. (Default)
Speaker is always on.
Speaker is off when receiving carrier and during dialing,
but on during answering.

Set Multi- or Fix- Mode Handshake
Automode detection is disabled.
Automode detection is enabled. (Default)

Return to On-Line Mode
Enters on-line data mode without a retrain. (Default)
Enters on-line data mode with a retrain before returning
to on-line data mode.

P

Qn

Sr=n

ATQ0
ATQ1

ATSr=n
ATS?

Set Pulse Dial
This command forces pulse dialing until the next T dial
modifier or T command is received.

Quiet Results Code Control
Enables result codes to the DTE. (Default)
Disables result codes to the DTE.

Read / Write S-Register
Sets S-Register "r" to the value n.
Reports the value of S-Register r.

Command

Description

7

8