Patton electronic 2190 User Manual
Page 10
Fax Class 2 commands (continued)
+FDIS:
Report remote capabilities
+FDIS=
Current sessions parameters
+FDR
Begin or continue phase C receive data
+FDT=
Data transmission
+FDTC:
Report the polled station capabilities
+FET:
Post page message response
+FET=N
Transmit page punctuation
+FHNG
Call termination with status
+FK
Session termination
+FLID=
Local ID string
+FLPL
Document for polling
+FMDL?
Identify model
+FMFR?
Identify manufacturer
+FPHCTO
Phase C time out
+FPOLL
Indicates polling request
+FPTS:
Page transfer status
+FPTS=
Page transfer status
+FREV?
Identify revision
+FSPL
Enable polling
+FTSI:
Report the transmit station ID
4.6 VOICE COMMANDS
This section describes the voice commands on the Model 2190.
The list below provides the voice command codes and its function.
#BDR
Select baud rate (turn off autobaud)
#CLS
Select data, fax, or voice.
#MDL?
Identify model
#MFR?
Identify manufacturer
#REV?
Identify revision level
#SPK=
Speakerphone setting
#TL
Audio output transmit level
#VBQ?
Query buffer size
Voice Commands (continued)
#VBS
Bits per sample
#VBT
Beep tone timer
#VCI?
Identify compression method
#VGT
Set playback volume in the command state
#VLS
Voice line select
#VRA
Ringback goes away timer (originate)
#VRN
Ringback never came timer (originate)
#VRX
Voice receive mode
#VSD
Enable silence deletion (no function, com-
mand response only).
#VSK
Buffer skid setting
#VSP
Silence detection period (voice receive)
#VSR
Sampling rate selection
#VSS
Silence detection tuner (voice receive)
#VTD
DTMF/tone reporting
#VTM
Enable timing mark placement
#VTS
Generate tone signals
4.3 REGISTERS
This section provides information on the Model 2190 S-registers.
The codes and functions to change or read registers are listed below.
Also included in this section is a chart on the register codes and its
function.
4.3.1 COMMANDS TO CHANGE OR READ REGISTERS
Listed below are the Model 2190 command guidelines to change
or read registers. This list provides the command codes and describes
the functions of the codes.
ATSn=???
Changes the value of a register.
"n" = number of register
??? = new value of register in decimal
17
18