Pioneer RM-V4000V - Manual (Page 52)

51
(5) Paste spacer A (BMR1073) to the top board of the
multi-projection unit and spacers B (BMR1074) to the
two sides at the
1234
1234
1234
position shown in the figure after
peeling off the seal.
* Paste after adjusting the
center of the top board
to that of spacer A.
* Paste without cover-
ing the fan.
(6) Insert the multi-projection unit from the rear of the
unit in this state.
Unit
(7) Attach the attachments R and L to the unit through the
top board of the unit using the screws (M6
×
20) and
then attach attachments R and L to the unit from the
back using screws (M6
×
20). (2 screws
×
2 locations).
(9) Attach the cover (BNE1012) to the top board of the unit
using the four screws (M5
×
15).
Screw (M5 × 15)
INSTALLATION AND ASSEMBLY
*Drop the screw-lock fluid to screws so as not to loosen.
(4 points)
(8) Check the Focus and reajust if necessary.