Pioneer RM-V4000V - Manual (Page 10)

9
Type
BNC connector
BNC connector
BNC connector
BNC connector
BNC connector
Slide switch
Tact switch
Tact switch
Tact switch
Tact switch
Tact switch
Tact switch
D-sub 25 PIN (Female)
Mini jack
DIN 6PIN
DIN 6PIN
D-sub 9PIN (Male)
Slide switch
BNC connector
BNC connector
BNC connector
BNC connector
BNC connector
Name
Control input terminal
Y (Luminance) input terminal
C (Color) input terminal
Video input terminal
Video output terminal
TERMINATE switch
COMBINATION switch
MULTI switch
COLOR MODE switch
INPUT switch
POWER switch
STATUS switch
RS-232C port
emote control connection ter
minal
Linked output terminal
Linked input terminal
RGB input terminal
RGB input select switch
RGB input terminal (R)
RGB input terminal
(G/composite sync)
RGB input terminal (B)
RGB input terminal
(Horizontal sync/composite
sync)
RGB input terminal (Vertical
sync)
No.
1
2
3
4
5
6
7
8
9
0
-
=
~
!
@
#
$
%
^
&
*
(
)
Function
Video input and Y/C input external switching control signal in-
put terminal
Luminance signal input terminal
Color signal input terminal
Video signal input terminal
Video input terminal 4 through-out terminal
Terminates the video input terminal 4 at 75 ohm
Turns on when linked to ABL
Turns on when used on multi screen
Switches the color temperature. 1:Normal use. 2:Re-exposure
Switches VIDEO input, Y/C input, RGB input.
Switches VIDEO input and Y/C input with the external control
signal 1 at VIDEO position
Power OFF:STANDBY (Red LED) lights up
Power ON:ON (Green LED) lights up
Accumulated duty time:Switch which displays setting states of
each switch on the screen.
RS-232C communication connector
Connected to adjusting remote control (optional)
Output terminal of ABL signal, remote control signal, and RS-
232C signal
Input terminal of ABL signal, remote control signal and RS-
232C signal
RGB signal input terminal
Switches RGB signal input terminal type
RGB signal R input terminal
RGB signal G and composite sync (Input signal G on sync) input
terminal
RGB signal B input terminal
RGB signal horizontal sync and composite sync (Only for input
signal H/V sync) input terminal
RGB signal vertical sync input terminal
GENERAL SPECIFICATIONS
• To turn off the power, use the POWER switch - of the unit, the RS-232C control, or wired remote control (optional). (If turned
off using the main POWER switch or by disconnecting the power cable from the outlet, the settings of the above 7 to -
switches and the state of the TV SYSTEM and convergence memory will not be recorded on the memory.)
Consequently when starting up or stopping the whole system by AC ON/OFF in setup conditions for a demonstration, it is
necessary to turn off the power using the above method to record each setting in the memory.
*: Counts only when the power is ON and signal has been input to the input function selected. If the main POWER switch is
turned off or the power cable is pulled out of the outlet while the power is on before one hour has passed, errors will occur
in the count.