Pioneer MEP-7000 - Manual (Page 67)

TROUBLESHOOTING
67
En
English
ERROR MESSAGE DISPLAY
When MEP-7000 is unable to operate properly, an error code is displayed on the display panel. Check the error code displayed against
the following table and take the recommended action to correct the error. If an error code other than any of the error codes listed in the
table below is displayed or if the same error code is displayed even after corrective action has been taken, contact your nearest Pioneer
Service Station or contact the store from which you purchased your player for assistance.
MEP-7000 UPDATES
Software for this unit may be updated to improve operation or functionality. For details consult the following support website:
http://www.prodjnet.com/support/
Error Code Error Type Description Possible cause and recommended action
E-7201 TOC READ ERROR Player unable to read TOC
data. Disc is cracked.
 Recommended action: replace disc.
Disc is soiled or dirty.
 Recommended action: clean disc.
If other discs play normally, the problem is with
the disc itself.
E-8301
E-8302
E-8303 PLAYER ERROR File loaded cannot be played
properly.
E-8304 DECODE ERROR File loaded cannot be played
properly. The file is not in a supported format.
 Replace with disc or file compatible with the
proper format.
E-8305 DATA FORMAT ERROR
E-8306 NO FILE
E-8307 USB WRITE FAILED Writing could not be
completed to the USB storage
device. The media has been write-protected.  Disable
the write-protect function.
 Replace the USB storage device.
E-9101 MECHANICAL TIME OUT Mechanical operation has
failed to complete within
specified time interval. Dust or some other form of foreign particles have
found their way into disc insertion slot.
 Recommended action: remove dust or other
foreign particles.
E-6002 AUDIO DSP PROGRAM
DOWNLOAD ERROR Program cannot be written to
AUDIO DSP. Consult your dealer or the nearest Pioneer Service
Station.
MEP-7000_7L_EN.book 67 ページ ２００８年３月５日 水曜日 午後６時４分