Philips HDRW 720/00-02 - Manual (Page 88)

86
PROBLEM SOLUTION
The wrong TV channel
was decoded
(recorded) after you
programmed a
recording using
ShowView System.
b The programme number of the TV channel is not available in the GUIDE Plus+ ® system or allocation is
wrong.
To change or check the channel data, proceed as follows:
1 Press GUIDE/TV .
2 Press A .
3 Select 'Editor' with C .
4 Select the TV channel using B or A .
5 Press C to go to the right tile.
In case you can receive the selected channel only via an external receiver, press the red
button to select the corresponding source.
6 Press the green button.
7 Enter the programme number of the TV channel using the number buttons.
If the source you have selected is an external receiver, enter the programme number that you
would also enter at the external receiver for this TV channel.
8 Confirm with OK .
There is nochannel
overview in the GUIDE
Plus+
® system
b DVD recorder is switched on: Switch off the DVD recorder to allow data transfer
b The TV channel that transmits the GUIDE Plus+ ® data is not set properly.
b External receiver (satellite receiver, set-top box, cable TV box, ...) (if available) is switched off: switch on the
external receiver
b G-LINK cable is not connected: Connect the G-LINK cable and make the necessary settings to control the
external receiver (see chapter 'The GUIDE Plus+
® system', section 'Installation of the 'External receiver
1'').
Missing or wrong TV
channel in the '
Grid'
screen
b Wrong local post code/country was entered
b Please check your correct channel line up in the 'Grid' screen.
Read therefore the section 'The 'Editor' screen.
When you press
GUIDE/TV the GUIDE
Plus+ ® setup screen will
appear
b The GUIDE Plus+ ® system was not completely installed or local post code was not entered.
1 Check the settings
2 Select the corresponding line using B or A and confirm with OK .
3 For more information on the individual functions, see chapter 'The GUIDE Plus+ ® system',
section 'Setting up the GUIDE Plus+ ® System'.
The external receiver
does not always react
to Remote control
signal.
b The Infrared (IR) Remote control signal interfere with the IR signal of the G-LINK transmitter.
Put the G-LINK transmitter closer to the front of the external receiver.
My external receiver
switches automatically
through the TV
channels
b If the DVD-Recorder is switched off ( STANDBY m button) the external receiver will be used from the
GUIDE Plus+ ® system via the DVD-Recorder.
If you want to watch TV-Channels from the external receiver, you have to switch the DVD-Recorder on.
There is picture or
sound interference on
TV reception:
b Before recording, select the recording mode as described in chapter 'Manual Recording', section 'Selecting the
recording mode (quality)'.
b Have your aerial checked.
b You will find information on how to change the TV system in 'Manual TV channel search' in 'Installing your
DVD recorder'.
Distorted sound
coming from a
connected hi fi
amplifier
b The DVD recorder is connected to the 'Phono-input' of your amplifier: This socket is provided only for a record
players without a preamplifier. Select a different audio input.
Before you call an engineer