Peavey TransTube 100 EFX - Manual (Page 6)

((110 0)) P PO OS ST T G GA AIIN N
This control sets the overall gain of the Lead channel.
((1111)) C CH HA AN NN NE ELL S SE ELLE EC CT T
This switch selects the channel (Lead or Clean). The ACTIVE CHANNEL LEDs (6) indicate the active
channel — green for Clean; red for Lead.
((112 2)) E EFFX X A AD DJJU US ST T
Pressing this control selects the effect. A yellow LED adjacent to the effect name will illuminate to
indicate the selected effect. Rotating this control clockwise changes the parameter of the active
effect according to the descriptions below. The surrounding LED ring indicates relative value of
the parameter being adjusted.
EFX ADJ PARAMETERS
Tremolo - Rate increase
Funk Wah - Sensitivity increase
Octaver - Wet/Dry mix Rotary Speaker - Rate increase
Flanger - Rate increase Phaser - Rate increase
Chorus - Rate increase/depth decrease
EFX amps are built with factory settings loaded into the presets. To return to the factory settings,
press and hold both the EFX ADJUST (12) and DELAY (14) controls while turning the amp on.
((113 3)) R RE EV VE ER RB B
This control adjusts the overall reverb level. The surrounding LED ring indicates level.
((114 4)) D DE ELLA AY Y
This control adjusts delay type, time, and volume. Three types of delay are available: SLAP
(1 repeat), ECHO (3-4 repeats), or INFINITE (5-6 repeats). The LEDs in each section of the control
indicate which type is active and volume level. Pressing the control twice sets the delay time to
the interval between presses.
((115 5)) P PO OW WE ER R S SW WIIT TC CH H
This switch applies power to the unit in the “ON” position. One of the ACTIVE CHANNEL LEDs (6)
will illuminate to indicate that the unit is on. Pressing the lower portion of the switch turns the
unit off.
6