Lincoln Electric 500 - Manual (Page 28)

C-2 ACCESSORIES C-2
TIG OPTIONS
K1783-9 PTA-26V TIG Torch
Air Cooled 200 amp torch (2 piece) equipped with
valve for gas flow control. 25 ft. (7.6m) length.
KP509 Magnum Parts Kit for PTA-26V TIG Torch
Magnum Parts Kit provides all the torch accessories
you need to start welding. Parts kit provides collets,
collet bodies, a black cap, alumina nozzles and tung-
stens in a variety of sizes, all packaged in an easy to
carry reclosable sack.
K870 Foot Amptrol®-Varies current while welding for
making critical TIG welds and crater filling. Depress
pedal to increase current. Depressing pedal fully
achieves maximum set current. Fully raising the pedal
finishes the weld and starts the after flow cycle on
systems so equipped. Includes 25 ft. (7.6m) control
cable.
K963-3 Hand Amptrol®-Varies current for making
critical TIG welds. Fastens to the torch for convenient
thumb control. Comes with a 25 ft. (7.6m) cable. (One
size fits all Pro-Torch TIG Torches.)
K2347-1 Precision TIG 185 Ready-Pak
For AC TIG Welding with square wave performance
use the AC generator of the Engine-Driven Welder to
supply the power. Easy setup. Includes torch, foot
amptrol, gas regulator and hose. Requires the
K1816-1 Full KVA adapter kit.
K2350-1 Invertec® V205-T AC/DC One-Pak™ Package
For AC TIG welding with square wave performance,
use the AC generator of the engine-driven welder to
supply the power. Easy setup. Includes torch, parts
kit, regulator and hose kit, Twist-Mate™ torch adapter,
work cable with Twist-Mate end and foot Amptrol®.
WIRE FEEDER OPTIONS
K449 LN-25 Wire Feeder
Portable CC/CV unit for flux-cored and MIG welding.
Includes Gas Solenoid & Internal Contactor.
K126-2 Magnum® 350 Innershield Gun (for LN-25)
For self-shielded wire with 15 ft. (4.5m) cable. For
.062-3/32” (1.6-2.4mm) wire.
KP653-3/32 Drive Roll and Guide Tube Kit (for LN-25)
For .068-3/32” (1.8-2.4mm) cored or solid steel wire.
K1802-1 Magnum® 300 MIG Gun
For .035-.045 (0.9-1.2mm) gas shielded wire.
Includes 15 ft. gun and cable assembly and connector
kit.
KP653-035S Drive Roll and Guide Tube Kit (for LN-25)
For .035-.040” (0.9-1.0mm) solid steel wire.
K487-25 Magnum SG Spool Gun
Hand held semiautomatic wire feeder. Requires SG
Control Module and Input Cable.
K488 SG Control Module
The Interface between the power source and the
spool gun. Provides control of the wire speed and gas
flow. For use with a spool gun.
K691-10 Input Cable (For SG Control Module)
For Lincoln engine power sources with 14-pin MS-
type connection, separate 115V NEMA receptacles
and output stud connections.
PLASMA CUTTING
K1581-1 Pro-cut 80
Cuts mild steel using the 3-phase AC generator power
from the engine driven welder.
VANTAGE 500 CUMMINS