Linksys PSUS4 - Manual (Page 13)

6 Chapter 3: Connecting the PrintServer
Overview
PrintServer for USB with 4-Port Switch
Chapter 3: Connecting the PrintServer
Overview
Before starting the physical installation, make a note of the PrintServer’s Default Name that is located on the
bottom of the PrintServer. There is a bar code sticker with an SC number printed on it (for example, SCA71107).
This number is used in the PrintServer driver installation.
Connecting the USB PrintServer to your Network
1. Plug one end of the Ethernet network cable into one of the PrintServer’s LAN Ports (1-4). (See Figure 3-1.)
2. Connect the other end of the cable into your networked hub, switch, or router. The distance between the
PrintServer and the other device should not exceed 328 feet (100 meters).
3. Use the USB cable to connect your printer to the PrintServer’s USB port. Plug the Type A connector end into
the PrintServer (Figure 3-2) and the Type B connector end into the printer.
4. Power on your printer.
5. Plug the power adapter cord into the PrintServer’s Power port, which is located on the right side of the
PrintServer. (See Figure 3-3.)
6. Plug the power adapter into an electrical outlet.
Figure 3-1: Connecting to the LAN Port
NOTE: The PrintServer does not have an on/off
power switch. Whenever its power adapter is
plugged into a power supply, the PrintServer is
powered on. The PrintServer can be powered on
before, during, or after your network is powered on.
Figure 3-2: Connecting to the USB Port
Figure 3-3: Connecting to the Power Port
IMPORTANT: Make sure to use the power adapter
that is supplied with the PrintServer. Use of a
different power adapter could damage the
PrintServer.