Linksys PCMPC200 v2 - Manual (Page 17)

EtherFast ® 10/100 CardBus PC Cards
13. Click Finish. When asked if you want to restart your computer, remove
the Driver Disk and click Yes.
14. Once your PC has rebooted and you log on to the network, double-click
the Network Neighborhood icon on your desktop. Ensure that you have
access to the network. If you do, you card has been properly installed.
• If you had previously installed any NT service packs, you must go back
and re-install those service packs now.
• If you need to install the TCP/IP protocol, refer to your system adminis-
trator or your Windows NT documentation. Linksys does not provide
technical support for the configuration or troubleshooting of the TCP/IP
protocol
Windows NT Installation and Setup for the EtherFast 10/100
CardBus PC Card is complete. Do not continue with the next set of
instructions. They are for NT users who already have their
networking configured.
29
Linksys Instant EtherFast ® Series
28
N No otte e: If you had
previously installed
any NT service
packs, you must re-
install them.
11. NT will copy the necessary network
drivers to your PC. When the copying is
complete, you will see a list of installed
bindings. Change the bindings settings
if needed and click Next. Click Next
again.
12. Choose either Workgroup or Domain, depending on the type of network
you're setting up. (Your NT user guide explains the difference between
Workgroups and Domains.) Click Next.
N No otte e:: For information and help on
choosing your bindings, services
and protocols, ask your network
administrator, or check your
Windows NT documentation
.