Lincoln Mountaineer 1997 - Manual (Page 70)

Energy absorbing sew pattern
The short plastic boot on the front
passenger safety belt covers an
energy absorbing sew pattern on
the safety belt. In the event of an
accident, the sew pattern may
release, and the orange REPLACE
BELT label may become visible. If
any part of the orange label is
exposed, the belt must be
replaced.
Failure to replace the
safety belt assembly under
the above conditions could result
in severe personal injuries in the
event of a collision.
Lincoln-Mercury recommends that
all safety belt assemblies used in
vehicles involved in a collision be
replaced. However, if the collision
was minor and a qualified
technician finds that the belts do
not show damage and continue to
operate properly, they do not need
to be replaced. Safety belt
assemblies not in use during a
collision should also be inspected
and replaced if either damage or
improper operation is noted.
REPLACE BELT
Seating and safety restraints
70