Lincoln Mountaineer 1997 - Manual (Page 174)

3. Remove electrical connector by
grasping wires and pulling
rearward.
4. Remove bulb retaining ring by
turning it 1/8 turn to free it from
the socket. Slide the ring off the
plastic base.
5. Carefully remove the bulb
assembly from its socket by gently
pulling it rearward.
6. With the flat side of the bulb’s
plastic base facing upward, insert
the glass end of the bulb into the
socket. You may need to turn the
bulb left or right to line up the
grooves in the plastic base with
the tabs in the socket.
7. Slip the bulb retaining ring over
the plastic base and lock it by
rotating it clockwise until you feel
it stop.
8. Push the electrical connector
into the rear of the plastic base
until you feel it “snap.”
9. Replace the bulb assembly into
the headlamp.
High-mount brakelamp
The high-mount brakelamp is
located just above the rear liftgate
window. For bulb replacement, see
your dealer.
Rear turn signals/brake/tail
lamps/backup lamps
The tail lamps, backup lamps and
the brake lamps are located in the
same bezel. Follow these steps to
Maintenance and care
174