Lanier 5622 - Manual (Page 41)

33
3. Setting Originals
This chapter explains the procedure for placing the original on the exposure
glass and in the automatic document feeder (ADF), and setting original scan
area and orientation according to the placement method.
To correctly display the top/bottom orientation of the scanned original on a
computer, the correct placement must be chosen by setup on the control panel
and scanner driver.
There are two orientations for placing the original. See the table below.
Note
❒ Normally, the original size is ( ) or ( ), but in the table below, a square orig-
inal is used to make the original orientation easy to understand. If the actual
original size changes, a combination of original orientation and the orienta-
tion specified on the control panel or scanner driver does not change.
Scanned original
Select the placement method.
Place the original on the ex-
posure glass. Place the original in the auto-
matic document feeder
(ADF).
Place the original.
(There are two original orienta-
tions.)
Place the
original so
that the top
edge touches
the top left of
the exposure
glass. Place the
original so
that top edge
touches the
rear of the ex-
posure glass. Place the top
edge of the
original first. Place the
original so
that the top
edge is set
into the ADF.
Speci-
fy the
orien-
tation.
When scanned by the
delivery scanner or
Document Server
(Specified on the con-
trol panel)
When scanned by the
TWAIN scanner
(Specified by the Scan-
ner Control dialog box)
[Standard 0deg.] [Right 90deg.] [Standard 0deg.] [Left 90deg.]
Original displayed on a compu-
ter