Land Pride RC5020 - Manual (Page 39)

37
Section 5: Maintenance & Lubrication
5/29/13 RC5020 (540 RPM) and RCM5020 (1000 RPM) Rotary Cutters 318-474M
Table of Contents
Step 2
Tighten the four hex nuts
uniformly until the clutch pack and
hub are loose.
Step 3
Bend all four retaining lugs out on
edge of clutch housing.
Step 4
Remove thrust plate with
Belleville Springs and lug rings to
access friction discs and hub for
inspection or service.
4-Plate Disassembly
Step 1
If included, remove end half
clamps.
Step 5
Inspect friction discs and hub.
23553
4-Plate Assembly
Step 2
Compress Belleville Springs to
the pressure plate by tightening
the four hex nuts and then placing
the assembly into the clutch
housing.
Step 3
Bend retaining lugs inward over
the Belleville Spring edges to
secure the spring before backing
the four hex nuts off.
Step 4
With lugs bent in, loosen the four
hex nuts completely to the end of
the threaded studs.
Step 5
Install end half clamps if
available.
Step 1
Place hub and friction discs into
the housing.
23553