LSI 7102XP-LC - Manual (Page 54)

3-8 Firmware Installation Procedure
Copyright © 2002 - 2005 by LSI Logic Corporation. All rights reserved.
Step 5. The MPTUtil program displays a menu of options ( Figure 3.5 ).
To update the firmware, select option a - Update Firmware.
Figure 3.5 MPTUtil Options
Step 6. When prompted, type the filename of the BIOS/Fcode update.
The update process commences and completes in about 20–
30 seconds.
Step 7. Exit the MPTUtil utility using the menu option q - Quit.
3.4 Advanced User: Adjusting Default Firmware Settings
Occasionally, a user may find it necessary to adjust default firmware
parameters set by LSI Logic during the original manufacturing process.
Adjustments to these parameters will affect future behavior of the
LSI Logic Corp. FC/SAS Serial EEPROM / FLASH Utility.
LSIMPTUTIL 1.00.00
Copyright (c) 2005 LSI Logic Corporation. All rights reserved.
*******************************************************************
Currents Port 0 Port 1
World Wide P/N... 0x100000062B092448 0x100000062B092449
World Wide P/N... 0x200000062B092448 0x200000062B092449
Topology......... Auto
Speed............ Auto
Device Pathing... All Paths to a device
Protocol Support. INIT TARG LAN
Firmware: LSIFC929X 1.02.12 (2005.06.15)
********************************************************************
a - Update Firmware
b - Update BIOS & Firmware
c - Upload current firmware to a file
d - Upload current BIOS to a file
f - Toggle Board Speed on Function 0
g - Toggle Board Speed on Finction 1
f - Toggle Topologies on Function 0
g - Toggle Topologies on Finction 1
l - Change Interrupt Coalescing Values on Port 0
m - Change Interrupt Coalescing Values on Port 1
x - Erase BIOS
y - Change Protocol Support
z - Change Adapters
q - Quit
Selection: