Lowrance electronic LCX-16CI User Manual
Page 6
2
Transducers (cont.)
Model
Part #
200 kHz “Pod” Transducer .......... PD-WDX ...................... 106-27
w/o temp for shoot-thru hull
50/200 kHz Dual Freq. ............... HS-50/200-DX .............. 106-23
“Skimmer” High Speed
Transom mount with
temp sensor
50/200 kHz Dual Freq. ............... THST-50/200-DX .......... 106-29
Bronze thru-hull mount
w/temp and speed sensor
INSTALLATION
Bracket
Install the unit in any convenient location, provided there is clearance
behind it when it is tilted for the best viewing angle. Holes in the bracket
base allow wood screw or through-bolt mounting. Make certain there is
enough room behind the unit to attach the power and other cables.
Once the best location is determined, use the bracket as a template and
mark the mounting holes and the hole for the cables. Drill a 1.0" hole for
the cables. Screw the bracket to the mounting surface.
IMPORTANT!
In order to pass all connectors through the 1" hole in the bracket and
dash, first pass the transducer connector up through the hole, then any
accessory cables. Next, pass the power cable down through the hole. Fill
the hole with a marine sealant. You can now wire the power cable.
9.6”
7.3”
3.7”
2.3”