Lightolier A0302 User Manual

Page 2

USE SPECIFIED LAMPS

ONLY!

For suspended ceilings:

T-Bar ANCHOR CLIPS

ACCESSORY No. 1956 (order separately) may be used
with 18” or 27” MOUNTING BARS or TELESCOPING
MOUNTING BARS for quick mounting (Fig. 6) or simply
wire MOUNTING BARS to ceiling members (Fig. 7)

IS:7084

:7084

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

A0302

Page 2 of 3

COMPANY

631 Airport Road, Fall River, MA 02720

T-BAR ANCHOR

CLIPS

ACCESSORY

WIRE

MOUNTING

BAR

FIG. 6

FIG. 7

For wood joist construction:

TELESCOPING

MOUNTING BARS No. 7994 (order separately) may be
used to secure MOUNTING FRAME (Fig.5).

NOTE: To insure proper installation it is important that MOUNTING FRAME always be
securely mounted to structural ceiling members.

TELESCOPING
MOUNTING BARS

MOUNTING

BAR

FIG. 5

B. INSTALL AND WIRE

FIXTURE

Install fixture in ceiling. Adjust fixture for proper alignment
with the ceiling (Step A) and then wire fixture. White fixture
lead to neutral supply lead. Bare fixture wire to supply
ground. Use wire-nuts (local hardware items). Place all
electrical connections in the J-BOX. Attach J-BOX COVER
onto J-BOX.

This fixture is equipped with an ADJUSTABLE SOCKET.
The socket is pre-set to provide a wide light beam, it can be
re-set in the field to provide alternate narrow light beam by
pushing socket holder in and turning counter clockwise.

Fixture #7082: - 250 Watt T-4 Tungsten-Halogen
Frosted (Mini-Can base)
Fixture #7084: - 400 or 500 Watt T-4 Tungsten-Halogen
Frosted (Mini-Can base)

Place LAMP PROTECTIVE GLASS SHIELD on top of
HOUSING SUPPORT (Fig.1).

WARNING: LAMP PROTECTIVE GLASS

SHEILD MUST BE USED AT ALL TIMES

AS RECOMMENDED BY LAMP

MANUFACTURER!

NOTE: SLIDE LATCHES permit removal of reflector from
within fixture for access to splices or for relamping from
above ceiling (Fig. 8) These latches must be snapped
into position to prevent reflector from disengaging
during relamping.

C. PUSH-IN (FIG.8)

Push APERTURE CONE or MULTI-GROOVE BAFFLE
straight up into MOUNTING FRAME until tight against
finished ceiling. RETAINING SPRINGS on MOUNTING
FRAME (Fig.1) will secure APERTUR CONE or MULTI-
GROOVE BAFFLE in place.

NOTE: To remove CONE or BAFFLE, turn CONE or
BAFFLE counterclockwise while pulling downward.
After starting, use both hands to remove, if desired.
See (Fig. 11)

FIG. 8

FIG. 9

FIG. 10

FIG. 11