AIRLESSCO Spray & Stripe 3600 - Manual (Page 16)

Spray Gun Operation
Reversible
Spray Tip
Tip Guard
Trigger Guard
MAJOR COMPONENTS OF SPRAY GUN &
REVERSIBLE REV-TIP ™
SPRAY GUN
Attach spray gun to airless unit and tighten fittings securely.
Set the gun safety latch. (Also may be called gun safety
lock, or trigger lock)
* The gun safety latch should always be set when the gun is
not being triggered.
Read all warnings and safety precautions supplied with the
spray gun and in product manual.
SPRAY TIP ASSEMBLY
1. Be sure the pressure relief procedure is followed
before assembling tip and housing to the gun.
2. Insert REV-TIP™ cylinder into the REV-GUARD
(guard housing assembly).
3. Guide the metal seat into REV-GUARD™ (guard
housing assembly) through the retaining nut & turn
until it seats against the cylinder.
4. Insert the O-Ring gasket onto the metal seat so that it
fits into the grooves.
5. Finger tighten REV-GUARD™ retaining nut onto the gun.
6. Turn guard in the desired position.
7. Completely tighten the retaining nut.
TO REMOVE CLOGS FROM SPRAY TIP
1. Lock gun safety latch.
2. Turn REV-TIP™ handle 180 degrees.
3. Disengage trigger lock and trigger gun into
the pail.
4. If the REV-TIP™ handle appears locked
(resists turning), loosen the retaining nut. The
handle will now turn easily.
5. Engage gun safety latch and return handle to
the spray position.
CLEANING SPRAY GUN CLEANING FILTER IN GUN HANDLE
Immediately after the work is finished, flush the gun out
with a solvent. Brush pins with solvent and oil them
lightly so they will not collect dried paint.
To clean the filter, use a brush dipped in an
appropriate solvent. Change or clean filters
at least once a day. Some types of latex may
require a filter change after four hours of
operation .
Gun Handle. Unscrew
from gun head to service
filter inside.
Gun Safety
Latch or Lock
™
14
Press up here & pull gently
to remove trigger guard
O-Ring Gasket
Metal Seat
REV-TIP™ Cylinder
Retaining Nut
Spray Position Shown
Reverse to
Unplug
REV-GUARD™
Guard Housing Assembly
Retaining Nut
Part # 561-026
Part # 561-029
Part # 561-XXX
G Thread 7/8" 561-002
F Thread 11/16" 561-001