Lincoln 1999 Continental - Manual (Page 13)

If you have a vehicle with the Driver
Select System, you have a DRIVER
ID control in place of the E/M
control.
• Refer to DRIVER ID
(if equipped) for DRIVER ID
control information.
• Refer to E/M (if equipped) for
E/M control information.
Operator selectable features
These features are controlled by the message center controls located to
the right of the instrument cluster.
System check
Pressing this control causes the
message center to cycle through a
status of each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for three seconds.
The sequence of the system check report is as follows:
• voltage level
• engine temperature
• oil level
• engine coolant level
• washer fluid level
• doors closed (driver and passenger side). This message can only be
reset by closing the door(s). If the RESET control is pressed, PLEASE
CLOSE DOOR will be displayed.
• trunk closed
• exterior lamps (front turn, brake and tail)
• fuel level
SYSTEM
DRIVER ID
MENU
TRIP
RESET
SELECT
DISPLAY
DTE ECON
VEHICLE HANDLING
SYSTEM
Instrumentation
13