LG AN110B-JD - Manual (Page 44)

Information
44
1
Turn off the projector and unplug the power cable.
Carefully place the lens side down on a
cushioned surface that will protect the lens
from damage.
(Allow the lamp to cool for 1 hour before
replacing it.)
2
Remove the two retaining screws on the lamp
cover with a screwdriver or similar objects and then
lift off the lamp cover.
Lamp case bolt
3
After lifting the lamp cover off, remove the two
retaining screws on the lamp case with a screw-
driver or similar objects.
4
Lift up the fixed wire knob on the lamp.
5 Pull out the handle slowly and remove the lamp
case.
6 Insert the new lamp gently into the correct position.
Make sure it is inserted correctly.
7
Tighten the screws you removed in step 3.
(Make sure it is fixed hardly.)
8 Replace the lamp cover and tighten the cover
screws.
(If the lamp cover is open, the lamp indicator flashes green
and the projector is not turned on.)
Replacing the Lamp
Bolt
Knob
Using and other lamp may cause damage to the projector or lamp.
Make sure the lamp cover is securely fastened. If the lamp cover is open, and the projector is not turned on.
In this case, contact your service center after checking the lamp to fix well.