Lenovo RD120 User Manual

Page 71

background image

4.

Remove

the

microprocessor

air

baffle

(see

5.

Install

the

VRM

in

the

VRM

connector.

a.

Touch

the

static-protective

package

containing

the

VRM

to

any

unpainted

metal

surface

on

the

outside

of

the

server.

Then,

remove

the

VRM

from

the

package.

b.

Turn

the

VRM

so

that

the

keys

align

correctly

with

the

VRM

connector

1 .

c.

Firmly

press

the

VRM

straight

down

into

the

connector

by

applying

pressure

on

both

ends

of

the

VRM

simultaneously.

d.

Make

sure

that

the

retaining

clips

are

in

the

locked

position

when

the

VRM

is

firmly

seated

in

the

connector.

6.

Locate

the

second

microprocessor

connector

on

the

system

board.

7.

Rotate

the

heat-sink

release

lever

to

the

fully

open

position.

8.

Lift

the

heat-sink

filler

out

of

the

server.

9.

Install

the

microprocessor:

a.

Touch

the

static-protective

package

that

contains

the

microprocessor

to

any

unpainted

metal

surface

on

the

server.

Then,

remove

the

microprocessor

from

the

package.

b.

Remove

the

protective

dust

cover

1 ,

tape,

or

label

from

the

surface

of

the

microprocessor

socket,

if

one

is

present.

Chapter

2.

Installing

optional

devices

57