LOREX Technology LH330 EDGE2 - Manual (Page 89)

71
PC and Mac Client Software for Remote Viewing
4 In the Interval drop-down menu, select the minimum interval between event notification
emails. For example, if you set the interval to 5 minutes, the DVR will only send alerts every 5
minutes when an event occurs.
5 Under the Receiver Email fields, enter the email address or addresses you would like alerts
to be sent to. You can enter up to 3 email recipients.
NOTE: You must enter a sender and receiver email address for email alerts to work.
6 (Optional) Enter a subject for the notification and a location (of the DVR) in the respective
fields.
7 Click Apply to save your settings, or click Clear to exit without saving. Click OK to close the
confirmation window.
8 Click Test Mail to send a test notification. Click OK to close the confirmation window.
NOTE: If you have made a mistake with either email addresses, you will not receive the
test notification.
9 Restart the DVR by disconnecting the power adapter from the rear panel of the DVR and
reconnect it.
NOTE: If you want to use your own SMTP server, select ON from the Send Mail Status
drop-down menu. Enter the address of your SMTP Server, port, user name, and
password. Check the Log on using secure authentication checkbox to log on using
secure authentication. Enter the sender’s email address and recipient’s email
address or addresses. Click Apply to save your settings and Test Mail to test the
notification.
Creating Custom Camera Titles
Title tab
Use the title tab to create custom titles
for your cameras. Custom titles are
displayed on the DVR but are not shown
while viewing remotely. You can also
save custom title configurations to your
computer and restore them later or
apply them to other DVRs.
To change camera names/titles:
1 C lick the Title tab from Setup Mode.
2 Under the Channel fields, enter a new
title for the camera. For example,
Parking Lot 1, Front Door, etc.
3 (Optional) (PC) Click Font Size
drop-down menu to change the size of
your camera titles. You can also drag
the slider to adjust the font size or
manually enter the font size.