Land Pride RCP2660 User Manual
Page 42
40
Section 6: Hydraulic Plumbing
RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter 316-111M
1/11/13
Hydraulic Cylinder Plumbing for Independent Control Option
Figure 6-8
27975
Solenoid Control Box
See Figure 6-
Cylinder Pump Plumbing for Independent Control Option
Figure 6-7
27967
Solenoid with Float
Control Capabilities
Shut Off
Valve
Filte
Pressure
Return Line
Overpressure
Relief Valve
35 Gallon
Reservoir
Cylinder Pump
See Figure 6-9
See Figure 6-9
See
Figure 6-9
Refer to “Independent Control” on page 19 for
assembly and set-up instructions.
Cylinder Pump Plumbing
Refer to Figure 6-7:
The oil is delivered to the solenoid valve block by a tractor
driven PTO cylinder pump receiving fluid from the 35
gallon reservoir. Excess oil is diverted back to the
reservoir through an overpressure relief valve. Return oil
is filter of particulates before dumping back into the
reservoir. Make certain the hydraulic reservoir shut-off
valve is fully open before engaging PTO.
Hydraulic Cylinder Plumbing
Refer to Figure 6-8:
Make sure “ARM 1”, “ARM 2”, and “Deck Pivot” cylinder
hoses are plumbed to ports (SA, SB, SC, SD, SE, and
SF) at the solenoid valve block on the cutter frame as
shown.