Linn PRE- AMPLIFIER - Manual (Page 32)

Notes on the list of sources:
NO SOURCE: No record path will be set.
KNEKT: When a record path on the AKURATE KONTROL is being used,
this setting will allow users of a KNEKT Line Driver system to change the
source they are listening to (which also changes the record path). To
protect a record path, select the required record option. Once recording
has finished, reselect the KNEKT option.
The available record modes are:
Notes:
The audio signal from the selected source is routed to either all of the
analogue and/or all of the digital outputs simultaneously. It is not
necessary to specify which output your recording device is connected
to.
The available record modes are dependent on whether the input signal is
analogue or digital.
For reasons of copyright protection some audio and video discs
incorporate systems that prevent them from being recorded.
LtRt 44.1 kHz
LtRt 48 kHz
LtRt 88.2 kHz
LtRt 96 kHz
LtRt As Input
Bit Perfect
Analog
Choose the option that suits your recording device’s
operating frequency. (With these options, multi-channel
signals are downmixed to two channels)
Output frequency is the same as the input frequency,
and multi-channel signals are downmixed to two
channels
Output frequency is the same as the input frequency
and there is no processing of the signal
Passes audio signals to the analogue outputs
O Op pttiio on n IIn nffo orrm ma attiio on n
ENGLISH
24 AKURATE KONTROL
AKURATE KONTROL pre-amplifier - english 15/5/07 15:17 Page 32