from the two 14-pin amphenols on the rear of the
unit. (K1728-2 Construction model of the Invertec
V350-Pro does not have the amphenols) These
supplies are intended to supply power for auxiliary
equipment like wire feeders and the TIG Module.

• 115VAC supply is rated at 2 amps and is protected

by a 2.5 amp breaker located by the amphenol.

• 42 VAC supply is rated at 5.5 amps and is protect-

ed by a 6 amp breaker located by the amphenol.

• 24 VAC supply is rated at 5.5 amps and is protect-

ed by a 6 amp breaker located by the amphenol.

Limitations

• The V350-Pro is not recommended for processes

other than those listed.

• The V350-Pro can only be used with the recom-

mended equipment and options.

Recommended Processes

Properly equipped, the Invertec V350-Pro supports
GMAW, FCAW, SMAW, GTAW and CAC-A
processes for a variety of materials, including mild
steel, stainless steel, cored wires, and aluminum.