Linksys Ethernet SGE2010 - Manual (Page 35)

SGE2010/SGE2010P Administration Guide 32
System Configuration
Using the Console
To edit the ISATAP tunnel settings
1. Select Edit., and then make the changes. Press the Tab key to move the cursor from one
field to the next.
NOTE: To enable or disable the ISATAP tunnel, move the cursor to the Status field, and then
press the Space Bar to toggle between ENABLE and DISABLE.
2. Press the Esc key to move the cursor to the Action list.
3. Select Save to save your settings
4. When the Operation complete message appears, press the Esc key to move the cursor to the
Action list.
IPv6 ISATAP Interface Show
You can use the ISATAP Interface Show screen to view the interface type and address.
To open this screen:
1. From the Switch Main Menu, select 1. System Configuration.
2. From the System Configuration Menu, select 6. IP Configuration.
3. From the IP Configuration menu, select 2. IPv6 Address Configuration.
4. From the IPv6 Address Configuration menu, select 5. ISATAP Interface Show.