Lathem 5000E Plus - Manual (Page 44)

20. SETTING THE SLAVE CLOCK
38 39
1
Press the [SELECT] button and position
the " " over the "SLAVE CLOCK"
mark. At that moment, the flashing digit
indicates "Clock Options".
(The flashing means it can be changed.)
2
Set the "Clock Options".
In case of the example, press the
[CHANGE] button to set at "1".
And then press the [SET] button.
At that moment, the flashing changes
from the "Clock Options" to "Signal
Options".
Set the "Signal Options".
In case of the example, press the
[CHANGE] button to set at "60".
And then press the [SET] button.
3
After you finish setting the slave
clock, press the [SET] button once
again.
Now the slave clock setting has been
completed. Replace the cover and
lock.
Important: If you do not complete Step
3, the Time Recorder will not print.
In this setup, you can select the Slave Clock.
Note:For this feature to be functional, the optional board must be installed in the Time
Recorder.
0.
1.
Clock Options
Disabled
Slave Clock 30.
60.
59.
Signal Options (for Slave Clock)
30-second reversal
60-second reversal
59-minute impulse
Setting the Slave Clock
Example: Set the Slave Clock and 60-second reversal.
SELECT CHANGE SET
SLAVE CLOCK
Clock Options
SELECT CHANGE SET
SLAVE CLOCK/DCF
SELECT CHANGE SET
SLAVE CLOCK
MO TU WE TH FR SA SU
Signal Options