Lathem 5000E Plus - Manual (Page 19)

14 14
3
Press the [SELECT] button and position
the " " under the "COMMENT" mark.
Setting the 1st comment line.
At the moment, the flashing digit
indicates "Character Position". And then
press the [SET] button.
At the moment, the flashing changes
from "Character Position" to "Character
Code".
SELECT CHANGE SET
Comment
Line
Character
Code
COMMENT
COMMENT
COMMENT
SELECT CHANGE SET
SELECT CHANGE SET
4
Set the "Character Code".
In case of example, the 1st character is
"A", then enter the character code
"02".
Refer to the "25. CHARACTER
CODE FOR ALPHANUMERIC"
Press the [CHANGE] button until the
correct character code appears. And
then press the [SET] button.
At that moment, the "Character
Position" changes from the 1st
character to the 2nd character.
The character code
"02" means "A".
SELECT CHANGE SET
The 2nd
Character
Character
Position