Lightolier Lytespan Track Lighting System 6450 - Manual (Page 4)

Job Information Type:
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2010 Philips Group • D0610
Lytespan Track Lighting System
6450
Page 4 of 4 Suspension Beam System
4' Housing 8' Housing
4' Individual Track 8' Individual Track or
Joiner Track
"L"-Housing Splice Box
COMPONENTS
Layouts of Stems and Cabels
Locate cables or stems uniformly along housings
not exceeding 8' spacing. In a straight run or open
pattern, locate first and last supports approximately
1' from the ends.
Position stem for power feed at least 6" from
the end of the housing (or housing/splice box)
to which power is to be fed.
Position cable for power feed 6" to 10"from the
housing/splice box to which power is to be fed.
The 10" distance may be increased by the amount
the cable is shortened on the job.
(1) 4’ Housing, (1) 4’lnd. Track
(1) 8’ Housing, (1) 8’ Joiner Track
Recommended Support: Stem or Wall Mounting Kit
(4) 4’ Housings, (4) 4’ Ind, Tracks
(2) 8’ Housings, (2) 8’ Joiner Tracks
(4) “L” Housing/Splice Boxes
(4) Sets of 2 Aux. Elect. Connectors
Recommended Support: Stem or Cable
(2) 4’ Housings, (2) 4’ Ind. Tracks
(1) 8’ Housing, (1) 8’ Joiner Track
(1) “L” Housing/Splice Box
(1) Set of 2 Aux. Elect. Connectors
Recommended Support: Stem or Cable
NOTE: Dimensions shown do not include End Plates.
SUSPENSION BEAM MOUNTING MAXIMUM LOAD*
Cables or Stems, spaced 8 Ft. apart 5 lb. Lytespots on 1 Ft. Spacing