Land Pride Skid Steer Rakes SR2690 - Manual (Page 18)

16
Section 3: Adjustments
SR2672 & SR2690 Skid Steer Powered Rakes 321-004M 4/05/12
Table of Contents
SR2672 End Plate Positioning
End plates are utilized to gather and keep rocks and
debris in front of the roller for the purpose of distributing
material over low areas.
Working Position
Refer to Figure 3-5:
The end plates are attached to the mounting pins on the
front side for gathering and distributing material while
traveling forward.
1. Install right hand end plate (#1) over the two side
support pins as shown.
2. Rotate spacer A1 under hitch pin spacer A2 and
insert hitch pin (#2) through spacers A1 & A2.
3. Secure hitch pin with hair pin cotter (#3).
4. Repeat steps 1 through 3 for left hand end plate.
SR2672 End Plate Assembly (Right Hand Side Shown)
Figure 3-5
24535
Storage Position
The end plates can be removed, turned over, and
repositioned on their mounting pins for storage during
final grading.
Refer to Figure 3-5:
1. Remove hair pin cotter (#3) and hitch pin (#2).
2. Remove right hand end plate (#1).
Refer to Figure 3-6:
3. Turn end plate over and insert Spacer B1 over
mounting pin B2.
4. Rotate spacer A1 over spacer A2 and insert hitch pin
(#2) up through spacers A2 & A1.
5. Secure hitch pin with hair pin cotter (#3).
6. Repeat steps 1 through 5 for left hand end plate.
SR2672 Final Grading Position of End Plates
Figure 3-6
21106