Land Pride Skid Steer Rakes SR2690 User Manual
Page 10
8
Section 1: Assembly & Set-up
SR2672 & SR2690 Skid Steer Powered Rakes 321-004M
4/05/12
Gauge Wheel Assembly
Figure 1-1
30940
By-Pass Valve
Hydraulic Hoses
Must Arch Up
Hydraulic
Motor
Section 1: Assembly & Set-up
Skid Steer Requirements
The Powered Rake is designed to fit on Skid Steer
Loaders with the following minimum requirements:
•
SR2672
SAE Lift Capacity . . . . . . . . . . . . . . . . . . . . . 1200 lbs.
Hydraulic Requirements . . . . . . . 11 GPM at 2200 psi
Maximum Hydraulic Pressure . . . . . . . . . . . 3500 psi
•
SR2690
SAE Lift Capacity . . . . . . . . . . . . . . . . . . . . . 1600 lbs.
Hydraulic Requirements . . . . . . . 15 GPM at 2500 psi
Maximum Hydraulic Pressure . . . . . . . . . . . 3500 psi
IMPORTANT: Ballast may need to be added to your
skid steer to maintain steering control and to prevent
tipping of the skid steer. Refer to your skid steer’s
operator manual to determine if additional ballast is
needed.
Hydraulic Motor Hose Assembly
Refer to Figure 1-1:
Check hoses between by-pass valve and hydraulic
motor. Hoses must arch up to prevent becoming
entangled in the hitch pivot points. If hoses do not arch
up, the following should be done:
1.
Loosen hose fittings at the valve by-pass.
2.
Rotate hoses until they arch up.
3.
Retighten hose fittings.
Gauge Wheel Assembly
Refer to Figure 1-1:
1.
Attach gauge wheels (#1) to the rear frame with
u-bolts (#4), lock washers (#3), and nuts (#2) as
shown.
2.
Tighten nuts to correct torque.